Are garden log cabins water resistant is a question we got asked all the time here at timberdise garden log cabins.
The very short simple answer to your question is a resounding yes!
Why would they not be?
Well, let’s take a look at some of the practical problems with a timber cabin which would make the log cabin not water resistant and fairly honestly not fit for purpose.The main thing to appear at instantly is the roof, that’s where you would imagine the main trouble would start (this is not always the scenario but that’s where we will start today). The main trouble with the roof would be to have the felt or roof shingles to not be mounted correctly. This is fairly easily done if this is something you have never done before and why it should always be carried out by an expert most especially if you are putting in a lot of your hard earned money on a timber cabin.
• Make sure that the overlaps are overliing in the correct way. You should always start felting at the bottom of the structure and felt upwards. By doing this you guarantee that the felt overlaps on top of the piece of felt that is further down the roof. This will guarantee there is a natural run off of the water, if you start felting at the top of the roof and you put the overlap from the bottom pieces over the top of the felt higher up when the rain works off it will operate beneath the felt and therefor trigger a leak. This is precisely the same when doing shingles, make sure you install from bottom upwards.
• Make sure the overlaps of the felt/shingles are fairly generous. You don’t want them to be just barely overliing because this could trigger rain to get between the felt sheets and this will trigger a leak
• Make sure you use ample felt nails. Ideally you want to be spacing the felt nails around 6 inches apart from each other. Always do this on both sides of the felt and dependent on the quality of the felt you are using possibly put another row of attach in the middle,possibly two rows but again this depends on the quality of the felt. Failure to put enough felt attach in there could result in the felt blowing off during a bad storm which would then leave your structure exposed to leaks.
• It is in addition vital that when you reach the overhang of the structure with the felt you attach the felt to side of the roof but DO NOT tuck the felt beneath the overhang of the roof as this limits the natural run off of the water. This can trigger early rotting of the structure and in some situations trigger the roof to water leak around the top corners of the structure as water could build up.
• Make sure you use the correct size fixings. If the roofing system boards on your structure are let’s say 10mm, you don’t want felt nails of 16mm. Doing this would trigger the felt nails to come completely through the roof. This would not appear cosmetically pleasing and would in addition be a real possibility of a leak in the structure. They way felt is now designed,there should be a watertight seal around the nail but throughout the seasons with wear and tear this may fail resulting in a leak.
• The most regularly neglected area on a timber cabin structure is the felt or shingles on the roof. This is normally because we can’t see it most of the time and it’s a lot more difficult to get up there and have a look,but this is precisely what you should do and I would suggest at least once a year or if you notice a leak. Because log cabins are not built as high as the typical house and the felt and shingles aren’t fairly as tough and durable as a typical house tile they require a little more attention. They are exposed to more elements on a daily basis because they are lower, this can result in a number of things from falling debris from plants, or another good example would be a kids’s toys getting thrown up there which would all trigger harm to the felt/shingles. Not to mention lots of bird excrement can rot the felt if it is in an area where natural rain can not permeate it to create a natural run off and cleaning system (for good example if your log cabin sits under a plant).
Timberdise install all of our log cabins, we do this because we know you are investing a lot of money into a timber cabin and you want it to be around for a long period of time. So the best way we can guarantee this takes place is to take care of the installation and make sure it is mounted correctly. We’ve been out to repair log cabins in the past built by non-skilled people and if the structure is not put together correctly then number one it won’t be safe but in addition it could trigger a failure in the structure to be water resistant.
A prime good example of this would be that the logs haven’t been constructed correctly on the walls. This would then trigger the log cabin to differ from the design as it was intended to be. At this point when the roof was mounted there might be voids between the roof and the wall. Voids could in addition appear on the walls of the log cabins themselves and in some situations if the initial build of the log cabin was so bad you would have no choice but to take down the log cabin and rebuild it.
This is why Timberdise Garden Buildings install all of our log cabins so you don’t have this to worry about. As you can imagine if there is an opening in the wall or an opening between the roof and the wall this would leave the log cabin open and it would most definitely water leak which is what we want to avoid at all costs.
I in addition want to bring attention to the floor covering a second. Having your log cabin mounted on a proper ground base is a must. That could be a Timberdise ground base,concrete base or a paved area. As long as they’re flat, level and solid you should be ok. Be mindful of where you put the log cabin,don’t put it anywhere that is at risk of flooding as just like the house that you live in. If the water level rises and there is no getaway for it then the log cabin will flood,that is regardless of how thick and tight your logs are.
Lastly let’s talk about sealants around the windows and doors. Make sure after you have treated your log cabin you fit the relevant sealants around the doors and the windows. The cabins don’t come with these fitted as standard, this is so you can treat the log cabin first and then apply the sealants afterwards. By not fitting the doors and windows with sealants then there’s a chance rain could permeate the inside of the log cabin, which again is easily fixed by applying sealants.
Also, occasionally most especially during the winter months, condensation can happen inside a log cabin. This is typical due to the cabins not having any insulation fitted, it is not a leak and can be fairly typical. We suggest at Timberdise to get a dehumidifier if you have electric access in there and leave it working during the chillier months. This will help take dampness out of the air and further increase the life-span of your log cabin.
If you comply with all the above strategies you should have a leak free log cabin for the duration of its life-span which can provide endless pleasure and relaxation. Keep in mind prevention is far better than the treatment.